Intermec CN50 User Manual page 65

CN50 Mobile Computer for Windows Mobile 6.1 User's Manual
Enabling WPA-PSK with Microsoft Security
Use the following procedure to enable WPA-PSK with Microsoft
security.
1 Make sure the communications and radio parameters on your
CN50 are configured.
2 Start Intermec Settings.
3 Choose Communications > 802.11 Radio > Microsoft Security.
4 For Infrastructure Mode, choose Infrastructure.
5 For Network Authentication, choose WPA-PSK. Data
Encryption automatically defaults to TKIP.
6 For Pre-Shared Key, enter the pre-shared key or the passphrase.
The pre-shared key must be a value of 32 hex pairs preceded by 0x
for a total of 66 characters. The value must match the key value on
the authenticator. The passphrase must be from 8 to 63 characters.
After you enter a passphrase, the CN50 internally converts it to a
pre-shared key.
This value must match the passphrase on the authenticator.
7 Save your settings.
Configuring 802.1x Security with Microsoft Security
Use the following procedure to configure 802.1x security with
Microsoft.
1 Make sure the communications and radio parameters on your
CN50 are configured.
2 Start Intermec Settings.
3 Choose Communications > 802.11 Radio > Microsoft Security.
4 For Infrastructure Mode, choose Infrastructure.
5 For Network Authentication, choose Open.
6 For Data Encryption, choose WEP.
7 For 802.1X Authentication, choose TLS or PEAP.
Chapter 2 — Connecting and Configuring the CN50
51