Replacing The Hot-Swap Hard-Disk-Drive Backplane - Lenovo ThinkServer TS430 Hardware Maintenance Manual

13. Align the top edge of the EMI-protective panel with the top side of the hard-disk-drive cage and then
pivot the EMI-protective panel down until it snaps into position.
Figure 78. Installing the EMI-protective panel
14. Close and lock the front door.
What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the installation, go to "Completing the parts replacement" on page 177. Then, you might
need to reconfigure RAID for your server. See "Configuring RAID" on page 73.

Replacing the hot-swap hard-disk-drive backplane

Attention: Do not open your server or attempt any repair before reading and understanding the "Safety information"
on page iii and "Guidelines" on page 85.
This topic provides instructions on how to replace the hot-swap hard-disk-drive backplane.
This topic applies only to server models that have hot-swap hard disk drives installed.
Before you begin, print all the related instructions or ensure that you can view the PDF version on another
computer for reference.
Note: Depending on the model, your server might look slightly different from the illustrations in this topic.
To replace the hot-swap hard-disk-drive backplane, do the following:
1. Remove all media from the drives and turn off all attached devices and the server. Then, disconnect all
power cords from electrical outlets and disconnect all cables that are connected to the server.
142
ThinkServer TS430 Hardware Maintenance Manual