Lenovo ThinkServer TS430 Hardware Maintenance Manual page 121

Attention: It is recommended that you replace the TR 700 Battery annually or after 500 recharging cycles,
whichever comes first.
Installing the TR 700 Battery
Attention: Do not open your server or attempt any repair before reading and understanding the "Safety information"
on page iii and "Guidelines" on page 85.
This topic provides instructions about how to install the TR 700 Battery on a ThinkServer RAID 700 Adapter if
one is installed on your server.
Before you begin, print all the related instructions or ensure that you can view the PDF version on another
computer for reference.
Note: Use any documentation that comes with the TR 700 Battery and follow those instructions in addition
to the instructions in this topic.
To install the TR 700 Battery, do the following:
1. Remove all media from the drives and turn off all attached devices and the server. Then, disconnect all
power cords from electrical outlets and disconnect all cables that are connected to the server.
2. Remove the server cover. See "Removing the server cover" on page 87.
3. Lay the server on its side for easier operation.
4. If a PCI card bracket assembly is installed in your server, remove the PCI card bracket assembly. See
"Removing and reinstalling the PCI card bracket assembly" on page 91.
5. Locate the ThinkServer RAID 700 Adapter, which is located in the PCI-E slot 3 on the system board.
6. Remove the ThinkServer RAID 700 Adapter, which is a kind of RAID card. See "Installing or removing
the RAID card" on page 103.
Note: Carefully handle the ThinkServer RAID 700 Adapter by its edges and place it on a flat, clean,
and static-protective surface after you remove it.
7. Touch the static-protective package that contains the TR 700 Battery to any unpainted surface on the
outside of the server. Then, take the TR 700 Battery out of the package.
.
Chapter 6 Installing, removing, or replacing hardware
109