Connecting cables for models with up to eight 2.5-inch SAS hot-swap hard disk drives and one
backplane
For models with up to eight 2.5-inch SAS hot-swap hard disk drives and one backplane, a RAID card
must be installed in the server.
The following cables, which come with the RAID card, are required:
• One or two 700 mm (27.56 inches) mini-SAS to mini-SAS signal cables depending on the number
of hard disk drives installed
• One 2-pin 200 mm (7.87 inches) RAID card to system board hard-disk-drive LED cable
Note: The option package for the RAID card is designed for different types of servers and might contain
additional cables that are not required for installation.
41
.
Chapter 3
Product overview