Lenovo ThinkServer TS430 Hardware Maintenance Manual page 159

5. Record the cable routing and connection. Then, disconnect the power supply assembly cables from
the system board and all drives. For server models with hot-swap hard disk drives, you also need to
disconnect the power cable(s) from the hot-swap hard-disk-drive backplanes.
6. Release the power supply assembly cables from the cable clips and ties in the chassis.
7. Remove the four screws
push the power supply assembly from the rear until it is released from the metal retaining tab
Figure 85. Releasing the non-hot-swap power supply assembly
1 at the rear of the chassis that secure the power supply assembly. Then,
.
Chapter 6 Installing, removing, or replacing hardware
2 .
147