Lenovo ThinkServer TS430 Hardware Maintenance Manual page 157

• For the 2.5-inch hot-swap hard-disk-drive cage, install the six screws to secure the backplane on
the cage.
Figure 83. Installing the 2.5-inch hot-swap hard-disk-drive backplane
12. Slide the hard-disk-drive cage into the chassis from the front until it snaps into position.
Note: The following illustration shows the 3.5-inch hard-disk-drive cage. For the 2.5-inch hard-disk-drive
cage, the installation procedure is the same.
Figure 84. Installing the hard-disk-drive cage
13. Reinstall all the hot-swap hard disk drives and dummy trays (if any) in the hard-disk-drive cage. See
"Installing or replacing a hot-swap hard disk drive" on page 128.
14. Refer to your note to reconnect the cables to the backplane.
15. Reinstall the front system fan. See "Replacing the front system fan" on page 158.
16. Reinstall the front bezel. See "Removing and reinstalling the front bezel" on page 89.
.
Chapter 6 Installing, removing, or replacing hardware
145