Lenovo ThinkServer TS430 Hardware Maintenance Manual page 152

8. Install the new non-hot-swap hard disk drive into a blue bracket by flexing the sides of the bracket and
aligning pin 1 , pin
drive so that the hard disk drive can be seated in the bracket.
Note: Do not touch the circuit board
Figure 76. Installing the non-hot-swap hard disk drive into the bracket
9. Slide the new non-hot-swap hard disk drive with bracket into the drive bay until it snaps into position.
140
ThinkServer TS430 Hardware Maintenance Manual
2 , pin 4 , and pin 5 on the bracket with the corresponding holes in the hard disk
3 on the bottom of the hard disk drive.