Lenovo ThinkServer TS430 Hardware Maintenance Manual page 131

5. Locate the TPM connector on the system board and then insert the TPM module into the TPM connector.
Figure 57. Installing the TPM module
What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the installation, go to "Completing the parts replacement" on page 177. Then, you can
configure the TPM function in the Setup Utility program. See "Configuring the TPM function" on page 68.
Removing the TPM module
Attention: Do not open your server or attempt any repair before reading and understanding the "Safety information"
on page iii and "Guidelines" on page 85.
This topic provides instructions on how to remove the TPM module if the server has one installed.
Before you begin, print all the related instructions or ensure that you can view the PDF version on another
computer for reference.
Notes:
1. Use any documentation that comes with the TPM module and follow those instructions in addition to
the instructions in this topic.
2. If you remove the TPM module, the TPM function is unavailable.
To remove the TPM module, do the following:
1. Remove all media from the drives and turn off all attached devices and the server. Then, disconnect all
power cords from electrical outlets and disconnect all cables that are connected to the server.
.
Chapter 6 Installing, removing, or replacing hardware
119