Completing The Parts Replacement; Reinstalling The Server Cover And Reconnecting Cables - Lenovo ThinkServer TS430 Hardware Maintenance Manual

What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the replacement, go to "Completing the parts replacement" on page 177.
• After a system board is replaced, do the following:
1. Start the Setup Utility program by pressing the F1 key, and then check the BIOS and BMC version.
2. Go to http://www.lenovo.com/drivers and follow the instructions on the Web page to download the
latest version of firmware. Then, install the firmware to your server.
3. Update the machine type, model number, and serial number of the system board. Either you will
be prompted to do this while upgrading the BIOS, or you can locate the files for updating the
VPD within the DOS BIOS package. For some servers, the VPD utility is available for download
at: http://www.lenovo.com/drivers
Note: If you want to use the Firmware Updater program, ensure that it contains the latest versions of
the firmware. You can go to http://www.lenovo.com/drivers and compare readme files of different
versions of the same firmware for an individual device.

Completing the parts replacement

This topic provides instructions to help you complete the parts replacement and turn on your server.
To complete the parts replacement, you must properly route the cables inside the server, reinstall the server
cover, reconnect all the external cables and, for some devices, update the firmware and run the Setup Utility
program to do further setup.

Reinstalling the server cover and reconnecting cables

Attention: Do not open your server or attempt any repair before reading and understanding the "Safety information"
on page iii and "Guidelines" on page 85.
This topic provides instructions on how to reinstall the server cover and reconnect cables to your server.
Attention: For proper cooling and airflow, reinstall the server cover before turning on the server. Operating
the server for extended periods of time (more than 30 minutes) with the server cover removed might
damage server components.
Before you begin, print all the related instructions or ensure that you can view the PDF version on another
computer for reference.
Note: Depending on the model, your server might look slightly different from the illustrations in this topic.
To reinstall the server cover and reconnect cables to your server, do the following:
1. Make sure that all components have been reassembled correctly and that no tools or loose screws are
left inside your server.
2. Make sure that all internal cables are routed correctly and secured by any cable clips or ties in the
server. Keep cables clear of the hinges and sides of the server chassis to avoid interference with
reinstalling the server cover.
3. If you have removed the front bezel, reinstall it. See "Removing and reinstalling the front bezel" on
page 89.
.
Chapter 6 Installing, removing, or replacing hardware
177