Lenovo ThinkServer TS430 Hardware Maintenance Manual page 73

Menu item
SATA Configuration
(set SATA configuration
parameters)
PCI Configuration (set PCI
configuration parameters)
Submenu item
SATA Mode
SATA Port0
SATA Port1
SATA Port2
SATA Port3
SATA Port4
SATA Port5
Onboard Graphics
Controller
Primary Graphics
Onboard LAN1 I/O ROM
Onboard LAN2 I/O ROM
Selections
• Power on • If you have selected Stay off,
• If you have selected Last
• If you have selected Power
• IDE Mode
Select SATA controller operation
mode. If you want to configure
• AHCI Mode
RAID, choose RAID Mode for the
• RAID Mode
SATA controller.
View the information about the
SATA device connected to the
SATA connector 0 on the system
board.
View the information about the
SATA device connected to the
SATA connector 1 on the system
board.
View the information about the
SATA device connected to the
SATA connector 2 on the system
board.
View the information about the
SATA device connected to the
SATA connector 3 on the system
board.
View the information about the
SATA device connected to the
SATA connector 4 on the system
board.
View the information about the
SATA device connected to the
SATA connector 5 on the system
board.
• Disabled Enable or disable the onboard
graphics controller.
• Enabled
• Onboard Choose a mode for primary
graphics. The Add-On option
• Add-On
requires a graphics card installed.
• Disabled Enable or disable the onboard
LAN1 I/O ROM.
• Enabled
• Disabled Enable or disable the onboard
LAN2 I/O ROM.
• Enabled
Chapter 5
Comments
the server will stay in the off
state.
State, the server will resume
to the last state.
on, the server will restart
automatically.
.
Configuring the server
61