Icom VE-PG2 Instruction Manual page 48

2
SELECTIVE CALL MODE APPLICATION
■ Using with a headset
S����� 9 O����������
• M�k��g � ��ll f��� ��h�� ����������v���.
q T urn ON the power to Transceiver 2, and then set its operating channel to the
same as Transceiver 1.
w H old down transceiver 2's [PTT], and then push [4]* and [#] to transmit DTMF
signals to connect to the headset through transceiver 1 and the VE-PG2.
* �4�� is the destination number used in this example. The number depends on the �Call �4�� is the destination number used in this example. The number depends on the �Call 4�� is the destination number used in this example. The number depends on the �Call �� is the destination number used in this example. The number depends on the �Call is the destination number used in this example. The number depends on the �Call
destination number setting,�� in �Numbering plan�� (p. 126).
e A calling notice tone sounds at the external headset. The headset operator must
turn ON the switch to communicate with the transceiver.
r H old down transceiver 2's [PTT], and then speak into the microphone. Release to
receive.
t H old down transceiver 2's [PTT], and then push [#] to transmit DTMF signals to
disconnect the communication route.
• Also, if the VE-PG2 receives no audio for 15 seconds, the communication route is
disconnected.
• M�k��g � ��ll f��� h���������
q T he power to Transceiver 2 must be ON, and its operating channel must be set to
the same as transceiver 1.
w T urn ON the Switch when you received a call from the headset through the
VE-PG2.
e O nly speak when the transceiver operator stops speaking. Pause briefly before
you begin, to confirm they have finished speaking.
r T urn OFF the Switch to disconnect the communication route to the transceiver.
• Also, if the VE-PG2 receives no audio for 15 seconds, the communication route is
disconnected.
48
�� in �Numbering plan�� (p. 126). in �Numbering plan�� (p. 126). �Numbering plan�� (p. 126). Numbering plan�� (p. 126). �� (p. 126). .
�Call Call