Icom VE-PG2 Instruction Manual page 60

3
VE-PG2 SETTING SCREEN
■ Connection setting (Bridge mode)
3-2 IP network connection Transceiver 1 (TRX1)–Transceiver 3
(TRX3) (Continued)
ï IP �����w��k ������������ ������u�
The screen shows the status of the [TRX1]–[TRX3] ports' network connection, and
has controls for their connection.
Place the mouse pointer on �Connection setting,�� and then on �IP network
connection,�� and then click on one of the Transceiver ports, TRX1, TRX2 or TRX3 and then click on one of the Transceiver ports, TRX1, TRX2 or TRX3
shown on the list.
• The [Reload] and [Connect]/[Disconnect] buttons will not selected in the Unicast mode if you
have not set �Connection IP address.��
q S�����u�
Displays ports [TRX1]–[TRX3] connection settings for the IP network.
• The VE-PG2 has 3 statuses (�Not connected,�� �During transmit,�� and �During receive��).
w [R��l���]
Click [Reload] to reload and display the current status of ports [TRX1]–[TRX3].
e [C��������]/[D�����������]
Connect or disconnect to or from the [TRX1]–[TRX3] ports.
[NOTE]
• You can confirm the connection status on this screen.
• [VoIP] lights green while one of the [TRX1]–[TRX3] ports is connected to IP network.
• You can confirm the connection status of the [TRX1]–[TRX3] ports by looking at the [TRX1]–
[TRX3] indicators light on the VE-PG2, or by referring to �Information list for IP connection.��
(p. 141)
60
�Connection setting,�� and then on �IP network Connection setting,�� and then on �IP network
click on one of the Transceiver ports, TRX1, TRX2 or TRX3 on one of the Transceiver ports, TRX1, TRX2 or TRX3 n one of the Transceiver ports, TRX1, TRX2 or TRX3
q
,�� and then on �IP network �� and then on �IP network
2 or TRX3
w
or TRX3
e