Icom VE-PG2 Instruction Manual page 15

S����� 9 O����������
q S et transceivers A2 and B2 AF volume to the 12 o'clock position.
w T urn transceivers A1 and B1 power ON, and select the same operating channel
as transceivers A2 and B2.
• See the transceiver's instruction manual when setting the channel, if necessary.
e While holding down transceiver A1's [PTT] in Area A, speak into the microphone
at your normal voice level to call transceiver B1 in Area B.
Release transceiver A1's [PTT] to receive.
r While holding down transceiver B1's [PTT] of Area B, speak into the microphone
at your normal voice level to reply to transceiver A1 in Area A.
Release transceiver B1's [PTT] to receive.
Example: Operating VE-PG2 in local area network.
Transceiver A1
Transceiver A2
(Port number: 21500)
If you connect the VE-PG2 to a global network (internet),
you can communicate anywhere through the IP network
without using hub.
Transceiver B1
(Port number: 21500)
BRIDGE MODE APPLICATION
Turn the transceivers' power ON, and
then set the Transceiver A2's volume
control to the 12 o'clock position.
CAUTION:
To connect the transceivers or repeaters, use only the following cables:
OPC-2073 (For the transceivers) or OPC-2074 (For the repeaters).
Connect the specified cables to [TRX1], [TRX2] or [TRX3] only.
Using another cable, like an Ethernet cable may damage the VE-PG2,
transceivers or repeaters.
[TRX1]
192.168.0.2
Connect to the transceiver A2's speaker jack.
NOTE: First, connect the transceiver
to the VE-PG2 using the optional
[TRX1]
OPC-2073. Then turn ON the power
to the transceiver and the VE-PG2.
Turn the transceivers' power ON, and
then set the Transceiver B2's volume
control to the 12 o'clock position.
CAUTION:
To connect the transceivers or repeaters, use only the following cables:
OPC-2073 (For the transceivers) or OPC-2074 (For the repeaters).
Connect the specified cables to [TRX1], [TRX2] or [TRX3] only.
Using another cable, like an Ethernet cable may damage the VE-PG2,
transceivers or repeaters.
[TRX1]
VE-PG2
[TRX2]
192.168.0.3
Connect to the transceiver B2's speaker jack.
NOTE: First, connect the transceiver
Transceiver B2
to the VE-PG2 using the optional
[TRX1]
OPC-2073. Then turn ON the power
to the transceiver and the VE-PG2.
'clock position. clock position.
[Area A]
[LAN]
VE-PG2
1 2 3 4 5
HUB
[Area B]
[LAN]
Transceiver B3
1
1
2
3
4
5
6
7
8
9
10
11
15