Cisco CB21AG Installation And Configuration Manual page 85

Chapter 5 Configuring the Client Adapter
Follow the steps below to enable LEAP authentication for this profile.
Perform one of the following on the Profile Management (Security) window:
Step 1
If you want to enable LEAP without WPA, choose 802.1x under Set Security Options and LEAP in
•
the 802.1x EAP Type drop-down box.
If you want to enable LEAP with WPA, choose WPA under Set Security Options and LEAP in the
•
WPA EAP Type drop-down box.
Note
Click Configure. The LEAP Settings window appears (see
Step 2
Figure 5-7
Cisco Aironet 802.11a/b/g Wireless LAN Client Adapters (CB21AG and PI21AG) Installation and Configuration Guide
OL-4211-02
Refer to the "Wi-Fi Protected Access (WPA)" section on page 5-16
on WPA.
LEAP Settings Window
Setting Security Parameters
for additional information
Figure 5-7).
5-25