Cisco CB21AG Installation And Configuration Manual page 156

Error Messages
Error Message Cannot load oemres.dll.
Explanation
Recommended Action
Error Message Cisco Aironet 802.11a/b/g wireless adapter software update can't
proceed. Please insert the adapter in the system and try again.
Explanation
inserted in your computer.
Recommended Action
Error Message DHCP failure.
Explanation
Recommended Action
administrator.
Error Message Entry must be xx characters long. Please enter xx more characters.
Explanation
contain the correct number of characters.
Recommended Action
WEP" section on page
Error Message Failed to initialize supplicant. This error may be due to the absence
of a valid machine certificate or the incomplete configuration of profiles.
Explanation
Recommended Action
that your client adapter's current profile has been configured properly.
Error Message In order to select an Ad Hoc network, you must have a Network Name. Do
you want to enter a Network Name?
Explanation
but a network name was not entered on the Profile Management (General) window.
Recommended Action
the SSID1 field on the Profile Management (General) window. Otherwise, click No.
Cisco Aironet 802.11a/b/g Wireless LAN Client Adapters (CB21AG and PI21AG) Installation and Configuration Guide
10-14
The oemres.dll file cannot be installed.
Uninstall the current client adapter software; then install the latest release.
You attempted to upgrade your client adapter's software when the adapter was not
Click OK, insert your client adapter, and start the upgrade process again.
The domain logon failed because of a DHCP failure.
Try again to authenticate. If this message reappears, contact your system
The static WEP key that you entered on the Define Pre-Shared Keys window does not
Re-enter the static WEP key following the guidelines in the
5-22.
The domain logon failed because the EAP supplicant could not be initialized.
Verify that a valid machine certificate has been loaded onto your computer and
You chose Ad Hoc for Network Type on the Profile Management (Advanced) window,
If you want to set up an ad hoc network, click Yes and enter a network name in
Chapter 10 Troubleshooting
"Enabling Static
OL-4211-02