Cisco CB21AG Installation And Configuration Manual page 119

Chapter 7 Viewing Status and Statistics
Table 7-6
Table 7-6
Status
Transmit Statistics
Frames Transmitted OK
Frames Retried
Frames Dropped
No ACK Frames
ACK Frames
RTS Frames
CTS Frames
No CTS Frames
Retried RTS Frames
Retried Data Frames
Receive Statistics
Beacons Received
Frames Received OK
Frames Received with Errors The number of frames that were received with an invalid checksum.
CRC Errors
Encryption Errors
Duplicate Frames
AP Mismatches
Data Rate Mismatches
Cisco Aironet 802.11a/b/g Wireless LAN Client Adapters (CB21AG and PI21AG) Installation and Configuration Guide
OL-4211-02
interprets each element of the Advanced Statistics window.
Advanced Client Adapter Statistics
Description
The number of frames that were transmitted successfully.
The number of frames that were retried.
The number of frames that were dropped because of errors or
collisions.
The number of transmitted frames that did not have their corresponding
Ack frame received successfully.
The number of transmitted frames that had their corresponding Ack
frame received successfully.
The number of request-to-send (RTS) transmissions that were
attempted.
The number of clear-to-send (CTS) frames that were received in
response to a successfully transmitted RTS frame.
The number of request-to-send (RTS) transmissions that were
unsuccessful. The access point sends CTS frames in response to the
client's RTS frames. This field keeps track of each time the client does
not receive a CTS back from the access point.
The number of request-to-send (RTS) frames that were retransmitted.
The number of normal data frames that were retransmitted.
The number of beacon frames that were received successfully.
The number of all frames that were received successfully.
The number of cyclic redundancy check (CRC) errors detected in the
data portion of the frame.
The number of frames that were received with encryption errors.
The number of duplicate frames that were received.
The number of times the client adapter tried to associate to an access
point but was unable to because the access point was not the adapter's
specified access point.
Note
The number of times the client adapter tried to associate to an access
point but was unable to because the adapter's data rate was not
supported by the access point.
Note
Refer to the Access Point 1 through Access Point 4 parameters
on page 5-12 for information on specifying access points.
Refer to the Wireless Mode parameter in
information on supported data rates.
Viewing Statistics for Your Client Adapter
Table 5-3 for
7-13