Cisco CB21AG Installation And Configuration Manual page 142

Enabling or Disabling Your Client Adapter's Radio
Note If your client adapter's radio is disabled before your computer enters standby or hibernate mode or
before you reboot the computer, the radio remains disabled when the computer resumes. You must enable
the radio to resume operation.
You can use ADU or ASTU to enable or disable the client adapter's radio. Follow the instructions below
to use ADU or refer to the
If your client adapter's radio is enabled, open ADU and choose Disable Radio from the Action
drop-down menu (see
If your client adapter's radio is disabled, open ADU and choose Enable Radio from the Action
drop-down menu (see
Cisco Aironet 802.11a/b/g Wireless LAN Client Adapters (CB21AG and PI21AG) Installation and Configuration Guide
9-10
"Enable/Disable Radio" section on page 8-7
Figure 9-4) to disable the radio.
Figure 9-4) to enable the radio.
Chapter 9 Routine Procedures
to use ASTU.
OL-4211-02