Cisco CB21AG Installation And Configuration Manual page 39

Chapter 3 Installing the Client Adapter
Step 25 When prompted to insert your client adapter, perform one of the following:
• If you are using a PC-Cardbus card, insert the card into your computer's Cardbus slot; then click
OK. If the Windows Found New Hardware Wizard appears, click Cancel.
Note
• If you are using a PCI card, click OK. You will insert the card into your computer after you have
finished installing the Install Wizard.
The Setup Status window appears (see
Figure 3-9
The installation process begins, and you are notified as each software component is installed.
When a message appears indicating that your computer needs to be rebooted, click OK and allow your
Step 26
computer to restart.
If you are using a PCI card, insert the card into your computer's PCI slot.
Step 27
Note
Cisco Aironet 802.11a/b/g Wireless LAN Client Adapters (CB21AG and PI21AG) Installation and Configuration Guide
OL-4211-02
Refer to the "Inserting a PC-Cardbus Card" section on page 3-13
inserting a PC-Cardbus card into your computer.
Setup Status Window
Refer to the "Inserting a PCI Card" section on page 3-14
into your computer.
Figure 3-9).
for instructions on inserting a PCI card
Installing the Client Adapter Software
for instructions on
3-11