Cisco CB21AG Installation And Configuration Manual page 81

Chapter 5 Configuring the Client Adapter
Table 5-4
Security Feature
Fast roaming (CCKM)
Reporting access points
that fail LEAP
authentication
MIC
TKIP
Broadcast key rotation
Cisco Aironet 802.11a/b/g Wireless LAN Client Adapters (CB21AG and PI21AG) Installation and Configuration Guide
OL-4211-02
Client and Access Point Security Settings (continued)
Client Setting
Choose WPA and LEAP; then set
LEAP settings
No settings required; automatically
enabled
No settings required; automatically
enabled
No settings required; automatically
enabled
Enable LEAP, EAP-TLS, or PEAP Set up and enable WEP and set
Setting Security Parameters
Access Point Setting
Use Cisco IOS Release 12.2(11)JA
or later, choose a cipher suite that is
compatible with CCKM, and
enable Network-EAP and CCKM
for the SSID
Note To allow both 802.1X
clients and non-802.1X
clients to use the SSID,
enable optional CCKM.
No settings required; automatically
enabled in the firmware versions
listed on page 5-17.
Set up and enable WEP with full
encryption, set MIC to MMH or
check the Enable MIC check box,
and set Use Aironet Extensions to
Yes
Set up and enable WEP, set TKIP to
Cisco or check the Enable Per
Packet Keying check box, and set
Use Aironet Extensions to Yes
Broadcast WEP Key Rotation
Interval to any value other than
zero (0)
5-21