Configuring the Client Adapter
Step 4
Perform one of the following:
•
•
Enabling PEAP (EAP-MSCHAP V2)
Follow the steps below to enable PEAP (EAP-MSCHAP V2).
Step 1
Click Properties. The Protected EAP Properties window appears (see
Figure E-6
Check the Validate server certificate check box if server certificate validation is required
Step 2
(recommended).
Cisco Aironet 802.11a/b/g Wireless LAN Client Adapters (CB21AG and PI21AG) Installation and Configuration Guide
E-14
If you chose Protected EAP (PEAP), follow the instructions in the
V2)"
section below.
If you chose PEAP, follow the instructions in the
page
E-16.
Protected EAP Properties Window
Appendix E
Configuring the Client Adapter through the Windows XP Operating System
"Enabling PEAP (EAP-GTC)" section on
"Enabling PEAP (EAP-MSCHAP
Figure
E-8).
OL-4211-02