Cisco CB21AG Installation And Configuration Manual page 40

Installing the Client Adapter Software
Step 28 If the Windows Found New Hardware Wizard appears after your computer reboots, click Next, allow the
wizard to install the software for the client adapter, and click Finish.
Step 29 If your network setup does not include a DHCP server and you plan to use TCP/IP, follow these steps
for your operating system.
• Windows 2000
a.
b.
c.
d.
e.
f.
Windows XP
•
a.
b.
c.
d.
e.
f.
If you are prompted to restart your computer, click Yes.
Step 30
Step 31 Now that your client adapter is properly installed, it is ready to be configured.
• If you are planning to configure your client adapter through ADU, go to
configuration profiles.
• If you are planning to configure your client adapter through the Windows XP Wireless Configuration
Manager, go to
Note If you experienced problems during or after installation, refer to
information.
Cisco Aironet 802.11a/b/g Wireless LAN Client Adapters (CB21AG and PI21AG) Installation and Configuration Guide
3-12
Double-click My Computer, Control Panel, and Network and Dial-up Connections.
Right-click Local Area Connection x (where x represents the number of the connection).
Click Properties.
In the Components Checked Are Used by This Connection field, click Internet Protocol
(TCP/IP) and Properties.
Choose Use the following IP address and enter the IP address, subnet mask, and default
gateway address of your computer (which can be obtained from your system administrator).
Click OK to close each open window.
Double-click My Computer, Control Panel, and Network Connections.
Right-click Wireless Network Connection x (where x represents the number of the
connection).
Click Properties.
In the This Connection Uses the Following Items field, click Internet Protocol (TCP/IP) and
Properties.
Choose Use the following IP address and enter the IP address, subnet mask, and default
gateway address of your computer (which can be obtained from your system administrator).
Click OK to close each open window.
Appendix E.
Chapter 3 Installing the Client Adapter
Chapter 4 to create
Chapter 10 for troubleshooting
OL-4211-02