Cisco CB21AG Installation And Configuration Manual page 54

Creating a New Profile
Step 4 When the Profile Management (General) window appears (see
profile (such as Office, Home, etc.) in the Profile Name field.
Figure 4-3
Note
Perform one of the following:
Step 5
If you want this profile to use the default values, click OK. The profile is added to the profiles list
•
on the Cisco Aironet Desktop Utility (Profile Management) window.
If you want to change any of the configuration parameter settings, follow the instructions in
•
Chapter
Management) window.
The profiles for PC-Cardbus cards are tied to the slot in which the card is inserted. Therefore, you must
Note
always insert your PC-Cardbus card into the same slot, create profiles for both slots, or export the
profiles from one slot and import them for the other slot.
Step 6 Go to the
selected automatically or go to the
profile.
Cisco Aironet 802.11a/b/g Wireless LAN Client Adapters (CB21AG and PI21AG) Installation and Configuration Guide
4-6
Profile Management (General) Window
If you are creating a profile after scanning for an available network, the SSID of the network
appears in the SSID1 field.
5. The profile is added to the profiles list on the Cisco Aironet Desktop Utility (Profile
"Including a Profile in Auto Profile Selection" section on page 4-7
"Selecting the Active Profile" section on page 4-8
Chapter 4 Using the Profile Manager
Figure 4-3), enter a name for your new
to enable the profile to be
to activate the
OL-4211-02