Enabling Peap (Eap-Mschap V2) - Cisco Aironet CB21AG Installation And Configuration Manual

Setting Security Parameters

Enabling PEAP (EAP-MSCHAP V2)

Follow the steps below to enable PEAP (EAP-MSCHAP V2) for this profile.
Perform one of the following:
Step 1
•
•
Note
Note
Click Configure. The Configure PEAP (EAP-MSCHAP V2) window appears (see
Step 2
Cisco Aironet 802.11a/b/g Wireless LAN Client Adapters (CB21AG and PI21AG) Installation and Configuration Guide
5-52
If you want to enable PEAP (EAP-MSCHAP V2) without WPA or WPA2, choose 802.1x under Set
Security Options and PEAP (EAP-MSCHAP V2) in the 802.1x EAP Type drop-down box.
If you want to enable PEAP (EAP-MSCHAP V2) with WPA or WPA2, choose WPA/WPA2/CCKM
under Set Security Options and PEAP (EAP-MSCHAP V2) in the WPA/WPA2/CCKM EAP Type
drop-down box.
If you want to enable CCKM on the client adapter, you must choose the WPA/WPA2/CCKM
security option, regardless of whether you want the adapter to use WPA or WPA2. The
configuration of the access point to which your client adapter associates determines whether
CCKM will be used with 802.1x, WPA, or WPA2.
Refer to the "WPA and WPA2" on page 5-19
Chapter 5 Configuring the Client Adapter
for additional information.
Figure 5-17).
OL-4211-05