Configure Date And Time Service - NETGEAR ProSafe SRX5308 Reference Manual

WARNING!
Do not try to go online, turn off the VPN firewall, shut down the
computer or do anything else to the VPN firewall until the VPN
firewall finishes the upgrade! When the Test light turns off, wait a
few more seconds before doing anything.
7. After the VPN firewall has completed its reboot process, log in to the web management
interface, click Monitoring to display the Router Status screen, and then verify that the VPN
firewall has the new software installed.
Note: In some cases, such as a major upgrade, it might be necessary to
erase the configuration and manually reconfigure your VPN firewall
after upgrading it. Refer to the release notes included with the
software to find out if this is required.

Configure Date and Time Service

Configure date, time, and NTP server designations on the Time Zone screen. Network Time
Protocol (NTP) is a protocol that is used to synchronize computer clock times in a network of
computers. Setting the correct system time and time zone ensures that the date and time
recorded in the VPN firewall logs and reports are accurate.

To set time, date, and NTP servers:
1. Select Administration > Time Zone. The Time Zone screen displays:
Figure 158.
ProSafe Gigabit Quad WAN SSL VPN Firewall SRX5308
Network and System Management
260