Create A Client To Gateway Vpn Tunnel - NETGEAR ProSafe SRX5308 Reference Manual

ProSafe Gigabit Quad WAN SSL VPN Firewall SRX5308
5. Activate the IPSec VPN connection:
a. Select VPN > Connection Status. The VPN Connection Status submenu tabs
display, with the IPSec VPN Connection Status screen in view.
Figure 80.
b. Locate the policy in the table, and click the Connect table button. The IPSec VPN
connection should become active.
Note: When using FQDNs, if the Dynamic DNS service is slow to update
its servers when your DHCP WAN address changes, the VPN tunnel
will fail because the FQDNs do not resolve to your new address. If
you have the option to configure the update interval, set it to an
appropriately short time.

Create a Client to Gateway VPN Tunnel

Figure 81.
To configure a VPN client tunnel, follow the steps in the following sections:
• Use the VPN Wizard Configure the Gateway for a Client Tunnel
• Use the NETGEAR VPN Client Wizard to Create a Secure Connection
Manually Create a Secure Connection Using the NETGEAR VPN Client
Virtual Private Networking Using IPSec Connections
140
on page 141
on page 143 or
on page 148