NETGEAR ProSafe SRX5308 Reference Manual page 39

ProSafe Gigabit Quad WAN SSL VPN Firewall SRX5308
Figure 21.
4. Configure the protocol binding settings as explained in the following table:
Table 7. Add Protocol Binding screen settings
Setting Description
Service From the drop-down list, select a service or application to be covered by this rule. If the
service or application does not appear in the list, you need to define it using the Services
screen (see
Local Gateway From the drop-down list, select one of the WAN interfaces.
Source Network The source network settings determine which computers on your network are affected by
this rule. Select one of the following options from the drop-down list:
Any
Single address
Address Range
Group
Services-Based Rules
All devices on your LAN.
In the Start IP field, enter the IP address to which the rule is applied.
In the Start IP field and End IP field, enter the IP addresses for the
range to which the rule is applied.
If this option is selected, the rule is applied to the selected group.
The group can be a LAN group or an IP (LAN) group.
Note: For information about LAN group, see
Hosts (LAN Groups)
see Create IP Groups
Connecting the VPN Firewall to the Internet
39
on page 83).
on page 67. For information about IP groups,
on page 114.).
Manage Groups and