NETGEAR ProSafe SRX5308 Reference Manual page 230

Note: For security reasons, the Deny Login from WAN Interface check
box is selected by default for guests and administrators. The
Disable Login check box is disabled (masked out) for
administrators.
4. Click Apply to save your settings.
Configure Login Restrictions Based on IP Address

To restrict logging in based on IP address:
1. Select Users > Users. The Users screen displays (see
2. In the Action column of the List of Users table, click the Policies table button for the user for
which you want to set login policies. The Policies submenu tabs display, with the Login
Policies screen in view.
3. Click the by Source IP Address submenu tab. The By Source IP Address screen displays.
(The following figure shows an IP address in the Defined Addresses table as an example.)
Figure 143.
4. In the Defined Addresses Status section of the screen, select one of the following radio
buttons:
• Deny Login from Defined Addresses. Deny logging in from the IP addresses in the
Defined Addresses table.
• Allow Login only from Defined Addresses. Allow logging in from the IP addresses
in the Defined Addresses table.
5. Click Apply to save your settings.
ProSafe Gigabit Quad WAN SSL VPN Firewall SRX5308
Managing Users, Authentication, and Certificates
Figure 140
230
on page 227).