Creating A Client To Gateway Vpn Tunnel - NETGEAR FVX538 - ProSafe VPN Firewall 200 Router Reference Manual

ProSafe VPN Firewall 200 FVX538 Reference Manual
After both firewalls are configured, go to VPN > IPsec VPN > Connection Status to display
the status of your VPN connections.
Figure 5-6
The tunnel will automatically establish when both the local and target gateway policies are
appropriately configured and enabled,
Note: When using FQDN, if the dynamic DNS service is slow to update their servers
when your DHCP WAN address changes, the VPN tunnel will fail because the
FQDN does not resolve to your new address. If you have the option to
configure the update interval, set it to an appropriately short time.

Creating a Client to Gateway VPN Tunnel

Figure 5-7
Follow these steps to configure the a VPN client tunnel:
• Configure the client policies on the gateway.
• Configure the VPN client to connect to the gateway.
5-6
v1.0, March 2009
Virtual Private Networking