Table of Contents
Advertisement
Single Channel Wide Ultra320 SCSI Adapter
To remove a single channel wide ultra320 SCSI adapter:
1.
Locate the PCI-X slot 1 riser connector. See Figure 4-2 in the Chapter 4 Connectors,
Switches, and LED Indicators.
2.
Remove the PCI riser board assembly. See "PCI riser board assembly" in this chapter.
3.
Remove a single channel-wide ultra320 SCSI adapter. See "Expansion Board" in this
chapter.
Reverse steps 2 through 3 to replace a single channel-wide ultra320 SCSI adapter. Use the
PCI card guide on the assembly to position the adapter in the socket.
Integrated SATA RAID Controller Module
To remove an integrated SATA RAID controller module:
1.
Locate the PCI-X slot 1 riser connector. See Figure 4-2 in the Chapter 4 Connectors,
Switches, and LED Indicators.
2.
Remove the PCI riser board assembly. See "PCI riser board assembly" in this chapter.
3.
Remove an integrated SATA RAID controller module. See "Expansion Board" in this
chapter.
Reverse steps 2 through 3 to replace an integrated SATA RAID controller module. Use the
PCI card guide on the assembly to position the module in the socket.
Fan Assembly
To remove the fan assembly:
1. Power down the server. See "Powering Down the Server" in this chapter.
2. Remove the access panel. See "Access Panel" in this chapter.
3. Lift the air baffle from the server chassis.
4. Disconnect the fan assembly power cables (1 to 4) from the fan connectors on the system
board.
HP ProLiant DL320 Generation 3 Server Maintenance and Service Guide
WARNING: To reduce the risk of personal injury from hot surfaces, allow the internal system
components to cool before touching them.
Removal and Replacement Procedures
2-17
Advertisement
Table of Contents
