Omron E5CZ User Manual page 51

Using the Support Software Port
Personal computer's USB port
Communications port
for Support Software
Bottom view of E5EZ
28
Note If the Cable is connected when the power to the Temperature Con-
troller is OFF, power will be supplied from the personal computer
and impose a load on the internal circuits of the Temperature Con-
troller.
2. Connect the Cable.
Connect the personal computer's USB port with the Support Software port
on the Temperature Controller using the Cable.
• Temperature Controller Connection Method
E5EZ
Communications port
for Support Software
Note Hold the connector when inserting or disconnecting the Cable.
3. Install the driver.
Install the driver to enable the Cable to be used with the personal comput-
er.
• Installation
When the Cable is connected with the personal computer, the OS detects
the product as a new device. At this time, install the driver using the instal-
lation wizard. For details on installation methods, refer to the user's man-
ual for the E58-CIFQ1 USB-Serial Conversion Cable.
4. Setting Setup Tool Communications Conditions
Set the communications port (COM port) number to be used for the Ther-
mo-Mini Setup Tool to the COM port number assigned to the USB-Serial
Conversion Cable.
Refer to the E58-CIFQ1 USB-Serial Conversion Cable Instruction Manual
and Setup Manual for details on how to check the COM port assigned to
the USB-Serial Conversion Cable.
The communications conditions for Setup Tool COM ports are fixed as
shown in the table below. Set the communications conditions for the Ther-
mo-Mini Setup Tool according to the following table.
Communications port
for Support Software
E5AZ
Communications port
for Support Software
Bottom view of E5AZ
Section 2-3
E5CZ
Bottom view of E5CZ
E5CZ-U
Bottom view of E5CZ-U