Omron E5CZ User Manual page 125

Operation Level
Setting
See
See
al-2
Alarm Value 2
Function
Setting
See
See
al-3
Alarm Value 3
Function
Setting
102
• During temperature input, the decimal point position depends on the cur-
rently selected sensor, and during analog input it depends on the "deci-
mal point" parameter setting.
Setting range Unit
−1999 to 9999
EU
Related Parameters
Input type: Page 119, Scaling upper limit, Scaling lower limit, Decimal point
(initial setting level): Page 121
Alarm 1 type (initial setting level): Page 124
Standby sequence reset: Page 133, Alarm 1 open in alarm: Page 134, Alarm
1 hysteresis: Page 135, Alarm 1 latch: Page 139 (advanced function setting
level)
This parameter is set to one of the input values "X" in the alarm type list.
• This parameter sets the alarm value for alarm output 2.
• During temperature input, the decimal point position depends on the cur-
rently selected sensor, and during analog input it depends on the "deci-
mal point" parameter setting.
Setting range Unit
−1999 to 9999
EU
Related Parameters
Input type: Page 119, Scaling upper limit, Scaling lower limit, Decimal point
(initial setting level): Page 121
Alarm 2 type (initial setting level): Page 126
Standby sequence reset: Page 133, Alarm 2 open in alarm: Page 134, Alarm
2 hysteresis: Page 135, Alarm 2 latch: Page 139 (advanced function setting
level)
This parameter is set to one of the input values "X" in the alarm type list.
• This parameter sets the alarm value for alarm output 3.
Default
0
Alarm 2 must be assigned.
The alarm 2 type must be set to
other than an upper and lower limit
alarm.
Default
0
Alarm 3 must be assigned.
The alarm 3 type must be set to
other than an upper and lower limit
alarm.
Section 5-3