Omron E5CZ User Manual page 164

Advanced Function Setting Level
rlrv
MB Command Logic Switching
Function
Setting
See
See
a1on
Alarm 1 ON Delay
a2on
Alarm 2 ON Delay
a3on
Alarm 3 ON Delay
Function
Setting
See
See
• .This parameter switches the logic of the MB command (communications
writing switch) for the SYSWAY communications protocol
• The MB command (communications writing switch) is the equivalent of
the MB command (remote/local switch) of the E5@J.
• The setting indicated by the shaded area is the default (same logic as
E5@J).
Set
value
OFF Communications writing enabled
(remote mode selection)
ON Communications writing disabled
(local mode selection)
(Terms in parentheses () are the terms used on the E5@J.)
Related Parameters
Communications writing (adjustment level): Page 108
Protocol setting (communications setting level): Page 149
Alarm 1, 2, or 3 outputs are prevented from turning ON until after the delay
times set in these parameters have elapsed.
• Set the time for which the ON delay is to be enabled.
• To disable the ON delay, set 0.
Setting range Unit
0 to 999 Second
Related Parameters
Alarm 1 to 3 type (initial setting level): Page 124 to 126
Communications must be supported.
CompoWay/F must be selected as
the protocol.
Text data of MB command
0000
Communications writing disabled
(local mode selection)
Communications writing enabled
(remote mode selection)
Alarm 1 must be assigned, and the
alarm 1 type must not be 0 or 12.
Alarm 2 must be assigned, and the
alarm 2 type must not be 0.
Alarm 3 must be assigned, and the
alarm 3 type must not be 0.
Default
0
Section 5-7
0001
141