Testing Connectivity To The Lan; Resolving Alarms - Avaya S8700 Installation Instructions Manual

Testing the complete configuration
Test type
Test type 100
Test Type 102
Test Type 105

Testing connectivity to the LAN

To test the external IP connections for the C-LAN, IP Media Processor, and VAL circuit packs, you must
ping the circuit pack and ping a known computer connected to your network. If everything is configured
correctly, the Result column on the Ping Results screen reads PASS. If it reads ABORT, verify the IP-
address information and check the connectivity, including the cabling.
1
Type
ping ip-address IPaddress board UUCSS
is the IP address of the circuit pack and UUCSS is the cabinet, and slot of the circuit pack.
2
Type
ping ip-address IPaddress board UUCSS
is the IP address of another computer beyond the gateway and UUCSS is the cabinet, and slot of
the circuit pack.

Resolving alarms

As a last step, inspect the alarms log.
Use the Maintenance Web Interface.
•
Click Current Alarms and see if any alarms were generated. If so, resolve any alarms that may
exist using the maintenance book for your configuration .
274
Test features
5.5 seconds of 1004 Hz tone at 0 dB
Quiet until disconnect; disconnect is forced after 1 minute
9 seconds of 1004 Hz tone at 0 dB
1 second of silence
Cycle is repeated until disconnect, which is forced after 24 hours
9 seconds of 1004 Hz tone at -16 dB
1 second of silence
9 seconds of 404 Hz tone at -16 dB
1 second of silence
9 seconds of 2804 Hz tone at -16 dB
30 seconds of silence
0.5 seconds of test progress tone (2225 Hz)
About 5 seconds of silence
Forced disconnect
Installing the Avaya S8700 Media Server with an Avaya G650 Media Gateway
and press Enter, where the variable IPaddress
and press Enter, where the variable IPaddress
December 2003