Ac Power - Avaya S8700 Installation Instructions Manual

AC power

Connecting the power cords
!
The AC power cord can connect to a properly rated power distribution unit, individual AC power
receptacles, or to an UPS. Avaya recommends a rack-mounted UPS.
To connect the power cords:
1
Be sure that the circuit breakers at the AC load center are OFF.
2
Connect the G650 Media Gateway to a UPS or to a "nonswitched" or "always on" electrical
outlet.
Checking AC power
Each G650 Media Gateway uses at least one auto-ranging (90 to 265 VAC) power supply:
•
47 to 63 hertz
•
500 watts
•
8.0 amps (90 to120 VAC) or 4.0 amps (200 to 265 VAC)
The AC power source for each power supply installed in the G650 Media Gateway can be either:
•
1 phase of 120 VAC with neutral (100 VAC for Japan) with 15-amp circuit breaker
•
1 phase of 220 or 240 VAC (200 VAC for Japan) with 10-amp circuit breaker.
Testing the AC outlet
!
The following recommended test equipment, tests, and diagrams are intended only for North
American installations at 110 to 125 VAC. For installations in other regions, have a licensed
electrician verify the ground and voltages.
!
If the AC outlet tests indicate that the power requirements are not met, your customer must contact
a licensed electrician. DO NOT install the system until all requirements are met.
Installing the Avaya S8700 Media Server with an Avaya G650 Media Gateway
December 2003
WARNING:
WARNING:
WARNING:
79