Avaya S8700 Installation Instructions Manual page 186

Connecting to the IP server interfaces
10
Type
show control interface
The IP address, subnet mask, and default gateway information will be displayed.
Verify that the proper information was entered.
11
If required, type
provided IP address for their gateway.
12
Press Enter to effect the changes.
13
If required, use the
enter VLAN and diffserv parameters for the IPSI. Use Help to obtain syntax guidelines for these
commands.
14
Type
reset
Answer Y to the warning.
15
Type
quit
16
Check the LCD. Verify that it has an I P with a filled-in V showing at the bottom. (See
LED display showing that the IPSI has a static IP address,
Figure 74: LED display showing that the IPSI has a static IP address
17
Disconnect the laptop from the faceplate.
18
Repeat for each IPSI circuit pack.
186
and press Enter.
set control gateway gateway
set vlan priority
and press Enter
NOTE:
Resetting the IPSI terminates the administration session. If further administration is
required, start a new telnet session to the IPSI.
to logoff the IPSI.
NOTE:
Control network settings (IP address, subnet mask, and gateway) become effective when
you exit the IPADMIN session.
NOTE:
Always use the arp -d 192.11.13.6 command (step 4) to clear the ARP cache on the
laptop before connecting to another IPSI. If the cache is not cleared the laptop appears to
hang and does not connect to the next IPSI.
Installing the Avaya S8700 Media Server with an Avaya G650 Media Gateway
and press Enter, where
, , , and
set vlan tag set vlan id
on page 186)
CLK
S
E
R
V
is the customer-
gateway
commands to
set diffserv
Figure 74,
December 2003