Cabling The Third Media Gateway; Cabling The Fourth Media Gateway - Avaya S8700 Installation Instructions Manual

9
If finished, reinstall the fan assemblies and tighten the 7 screws. (All knurled screws must be
tightened securely so that they cannot be loosened without the use of a tool.) Otherwise continue
to

Cabling the third media gateway

Cabling the third media gateway
1
If not already removed, remove the fan assemblies from media gateways B and C.
2
Remove the left TDM/LAN bus terminator from media gateway B, and install it at the right end of
the TDM/LAN bus in media gateway C.
3
Remove the nuts on the posts of the plates covering the bottom left TDM/LAN cable routing slot
of media gateway C and the top left TDM/LAN cable routing slot of media gateway B.
4
Remove the left slot cover on top of media gateway B and the lower left slot cover of media
gateway C to open the slots.
5
Pull open the EMI Gasket, and pass the TDM/LAN bus cable through the routing slots in both
media gateways. Push the free end of the EMI Gasket back in place.
6
Install the lower terminator of the TDM/LAN bus cable on the left end of TDM/LAN bus in
media gateway B. Make sure the arrows on the back of the cable terminators point upward.
7
Install the upper terminator of the TDM/LAN bus cable on the left end of the TDM/LAN bus in
media gateway C.
8
Flip over the routing slot plates and reinstall both. Once the plates are reinstalled, the ends of the
routing slots are covered.
9
If finished, reinstall the fan assemblies and tighten the 7 screws. (All knurled screws must be
tightened securely so that they cannot be loosened without the use of a tool.) Otherwise continue
to

Cabling the fourth media gateway

Cabling the fourth media gateway
1
If not already removed, remove the fan assemblies from media gateways C and D.
2
Remove the right TDM/LAN bus terminator from media gateway C, and install it at the left end of
the TDM/LAN bus in media gateway D.
3
Remove the nuts on the posts of the plates covering the bottom right TDM/LAN cable routing slot
of media gateway D and the top right TDM/LAN cable routing slot of media gateway C.
4
Remove the left slot cover on top of media gateway C and the lower left slot cover of media
gateway D to open the slots.
5
Pull open the EMI Gasket, and pass the TDM/LAN bus cable through the routing slots in both
media gateways. Push the free end of the EMI Gasket back in place.
6
Install the lower terminator of the TDM/LAN bus cable on right end of TDM/LAN bus in media
gateway C. Make sure the arrows on the back of the cable terminators point upward.
7
Install the upper terminator of the TDM/LAN bus cable on the right end of the TDM/LAN bus in
media gateway D.
8
Flip over the routing slot plates and reinstall both. Once the plates are reinstalled, the ends of the
routing slots are covered.
9
If finished, reinstall the fan assemblies and tighten the 7 screws on each media gateway. (All
knurled screws must be tightened securely so that they cannot be loosened without the use of a
tool.) Otherwise continue to
86
Cabling the fifth media gateway
Installing the Avaya S8700 Media Server with an Avaya G650 Media Gateway
on page 86.
on page 86.
on page 87.
December 2003