Cabling The Fifth Media Gateway - Avaya S8700 Installation Instructions Manual

Cabling the fifth media gateway

1
If not already removed, remove the fan assemblies from media gateways D and E.
2
Remove the right TDM/LAN bus terminator from media gateway D, and install it at the left end
of the TDM/LAN bus in media gateway E.
3
Remove the nuts on the posts of the plates covering the bottom right TDM/LAN cable routing slot
of media gateway E and the top right TDM/LAN cable routing slot of media gateway D.
4
Remove the left slot cover on top of media gateway D and the lower left slot cover of media
gateway E to open the slots.
5
Pull open the EMI Gasket, and pass the TDM/LAN bus cable through the routing slots in both
media gateways. Push the free end of the EMI Gasket back in place.
6
Install the lower terminator of the TDM/LAN bus cable on right end of TDM/LAN bus in media
gateway D. Make sure the arrows on the back of the cable terminators point upward.
7
Install the upper terminator of the TDM/LAN bus cable on the right end of the TDM/LAN bus in
media gateway E.
8
Flip over the routing slot plates and reinstall both. Once the plates are reinstalled, the ends of the
routing slots are covered.
9
Reinstall the fan assemblies and tighten the 7 screws on each media gateway. (All knurled screws
must be tightened securely so that they cannot be loosened without the use of a tool.)
Installing the Avaya S8700 Media Server with an Avaya G650 Media Gateway
December 2003
87