Specifying Copy Settings - Konica Minolta Di1610f Advanced Information

7
7.6

Specifying Copy Settings

When the machine is turned on or the [Panel Reset] key is pressed, the
machine is automatically reset to its initial mode. By changing the default
settings, you can change the initial mode. Refer to the following table for
the default settings for each function.
No. Name
1 PAPER PRIORITY
2 DENSITY
PRIORITY
3 DENSITY LEVEL
(A) *(A) : Auto
4 DENSITY LEVEL
(M) *(M) : Manual
5 OUTPUT
PRIORITY
6 RESOLUTION
7-18
Description
The tray that is given priority can be set to either "TRAY1" or
"TRAY2".
• The factory default setting is "TRAY1".
The density that is selected when the machine is turned on or
the [Panel Reset] key is pressed can be set to "AUTO",
"MANUAL" or "PHOTO".
• The factory default setting is "AUTO".
The default Auto density level setting can be set to "LIGHT (–
1)", "NORMAL (0)" or "DARK (+1)".
• The factory default setting is "NORMAL (0)".
The default manual density level setting can be set to one of
nine levels between –4 and +4, with the normal print density at
0.
If a smaller number (toward –) is selected, the print becomes
lighter. If a larger number (toward +) is selected, the print
becomes darker.
• The factory default setting is "NORMAL (0)".
The finishing setting that is selected when the machine is
turned on or the [Panel Reset] key is pressed can be set to
"NON" or "SORT".
• The factory default setting is "NON".
The default resolution when scanning with the Auto Document
Feeder can be set to "600 dpi × 300 dpi" or "600 dpi × 600 dpi".
• The factory default setting is "600 dpi × 300 dpi".
Using the Utility Mode
Di1610f