Table of Contents
Advertisement
8
Symptom
The printed output has dark
specks or spots.
The printed output has lines.
The printed output on the
copy is not aligned properly.
The printed page is curled.
8-26
Possible Cause
The Original Glass surface is
dirty.
The Original Pad is dirty.
The original is highly
transparent.
The original is 2-sided.
Something is sticking to the
Original Glass (when the
Auto Document Feeder is
used).
The Drum Cartridge has
reached the end of its
service life.
The original is not placed in
the correct position.
The original may not be
suitable for use in the Auto
Document Feeder.
The paper guides are not
pressed up against the paper
stack in the tray.
The paper has an excessive
curl.
The paper that was used
curls easily (as with recycled
paper).
When a Message Appears
Action
Wipe the Original Glass
clean with a soft, dry cloth.
Wipe the Original Pad clean
with a soft cloth dampened
with neutral detergent.
Place a blank sheet of paper
over the original.
If a thin double-sided
document is being printed,
the information on the back
side may be reproduced in
the print. Press the [ ] key
and select a lighter print
density.
Wipe the Original Glass
clean with a soft, dry cloth.
Contact your service
representative.
Place the original correctly
on the Original Glass against
the Original Scales.
Or, load it in the Auto
Document Feeder correctly
along the Document Guide
Plates.
Raise the Auto Document
Feeder and place the original
on the Original Glass
correctly against the Original
Scales.
Slide the paper guides
against the edges of the
paper stack.
Smooth out curls in the
paper and reload the paper
stack in the tray.
Remove the paper from the
paper tray, turn it over, and
then load it again.
Change the paper.
Ö
Di1610f
Advertisement
Table of Contents
