Jump Start With Jumper Leads; Jump Start With An Another Vehicle Or Battery - SSANGYONG NEW CHAIRMAN Owner's Manual

JUMP START WITH JUMPER LEADS

JUMP START WITH AN ANOTHER VEHICLE OR BATTERY

1
1. Prepare the jump cable.
2. Place an another vehicle that has 12 V of power near to
discharged vehicle.
3. Switch off all electrical accessories for the discharged
vehicle.
P
4. Place the shift lever to in the discharged vehicle and ap-
ply the parking brake.
5. Connect the jumper cable as following order:
(1) + terminal of the discharged battery
(2) + terminal of the charged battery
(3) – terminal of the charged battery
(4) Rear towing hook in the discharged vehicle
IN CASE OF EMERGENCY
11-2
Page 2
6. Start the engine with the booster battery and slightly rev
7. Attempt to start the engine of the vehicle with the discharged
8. After starting the engine, carefully disconnect the jumper
3
4
2
up the engine.
battery.
cables in the reverse order of connection.
CAUTION
Be careful on the battery terminal polarity when you connect the
cables. The negative and the positive should not be changed.
Connect the '-' cable of discharged battery to the rear towing hook.
If it is connected to the battery directly, it may cause an explosion
due to the generated gas from battery. However, if the contact
point of the hook is painted, it may not apply an electric current.
Make sure that the battery providing the jump start has same volt-
age as the battery in your vehicle(12V).
The polarity of battery, i.e. the connections for positive and nega-
tive cables, must not be interchanged.
Make sure that the '+' terminal will not contact to the vehicle body.
While connecting the jumper cables, make sure that the negative
(–) and positive (+) cables never touch each other. Otherwise
sparks might cause an explosion of the battery.
Battery fluid contains acid that can burn you. Do not allow battery
fluid to contact eyes, skin, or painted surfaces. If you accidentally
get it in your eyes or on your skin, flush the place with water and
contact your doctor.
A battery generates the gas which is flammable and explosive.
This gas could be exploded due to the spark when connecting
the jump cables. Make sure that the booster battery has the same
voltage rate with the discharged battery.
When starting your vehicle with jumper cable, turn off the engine
of the boost vehicle and connect the jumper cables
Never try to start the engine with pushing the vehicle.
2006-10-02, ¿ÀÈÄ 5:59