Seat Belt - SSANGYONG NEW CHAIRMAN Owner's Manual

SEAT BELT

1. Three Point Seat Belt
Height Adjustor
1. Sit back in the seat with the seatback in an upright
position and wear the seat belt.
2. If the shoulder belt (A) crosses your neck, then ad-
just the seat belt height with height adjustor (front
seat).
3. Pull out the latch plate (2) from the retractor (1).
Check if the seat belt is not twisted.
4. Position the shoulder belt (1) across the body and
the lap belt (B) as low as possible across the hips.
Insert the latch plate (2) into the buckle (4) until it
clicks.
5. Pull the latch plate to make sure it is securely locked.
6. To remove the belt, press the red button (3) on the
buckle.
SEAT BELT AND AIR BAG
8-4
Page 4
2. Lap Belt (Rear Center Seat)
1. Pull the latch plate (2) to position the lap belt (3)
across the hips as low as possible.
2. Insert the latch plate into the buckle (1) until it clicks.
3. Pull the latch plate to make sure it is securely
locked.
4. To lengthen, hold the latch plate (2) at right angle
to the belt and pull the belt. To shorten, pull the
free end of the belt
away from the
latch plate, then
pull the belt clip to
take up the slack.
5. To remove the belt, press the red button (4) on the
buckle.
2006-10-02, ¿ÀÈÄ 5:58