Starting The Engine; Engine Stop - SSANGYONG NEW CHAIRMAN Owner's Manual

STARTING THE ENGINE

1. Apply the parking brake.
2. Make sure that there are no persons or obstacles in the
danger area around the vehicle.
"P"
3. Move the shift lever to the
brake pedal.
"ON"
4. Turn the ignition key to position.
"START"
5. Turn the ignition key to the
it until the engine starts. But do not hold the ignition key at
"START"
the position for more than 10 seconds.
6. If the engine fails to start, even if the engine does not start,
"LOCK"
turn the key back to the
seconds.
7. Do not operate the starter for more than 10 seconds at a
time. (The starter motor may be damaged.)
8. The engine in an automatic transmission equipped vehicle
can be started only when the shift lever is at the
"N"
position.
"ACC"
9. Do not leave the key at the
when engine is not running. Otherwise, the battery could
run down.
Page 3

ENGINE STOP

1. Keep the brake pedal depressed even after the vehicle has
2. Place the gear shift lever to
position and depress the
3. Apply the parking brake.
4. Remove the ignition key from the key cylinder.
position and hold
position and wait for 10
"P"
or
"ON"
or position
been stopped.
"P"
position.
CAUTION
The vehicle is controlled by various electronic control systems,
which may malfunction if any device generating electromagnetic
fields or waves is used near the ignition key or the vehicle.
SAFETY PRECAUTIONS
2006-10-02, ¿ÀÈÄ 5:55
1-3