Configuration Summary - ZyXEL Communications P-2612HNU-Fx User Manual

Chapter 5 WAN Setup
5.3.1.4 Routing and DNS Server
Click Next in the screens shown in
shows for both Ethernet and DSL WAN interfaces except when you select
Bridging as a service type.
Note: If you configure only one IPoA connection using the ATM interface on the
ZyXEL Device, you must enter the static DNS server address.
Figure 26 Network > WAN > Internet Connection: PPPoE, PPPoA, IPoE or IPoA
The following table describes the labels in this screen.
Table 19 Network > WAN > Internet Connection: PPPoE, PPPoA, IPoE or IPoA
LABEL
Selected WAN
Interfaces
Obtain DNS info
dynamically
Use the following
Static DNS IP
address
Primary DNS
server
Secondary
DNS server
Back
Next

5.3.1.5 Configuration Summary

Click Next in the previous section to open this read-only screen that shows the
current WAN connection settings.
112
Section 5.3.1.3 on page
DESCRIPTION
Select a WAN interface through which you want to obtain a system
default server and DNS server.
Select this to have the ZyXEL Device use the DNS server addresses
assigned by your ISP.
Select this to have the ZyXEL Device use the DNS server addresses
you configure manually.
Enter the first DNS server address assigned by the ISP.
Enter the second DNS server address assigned by the ISP.
Click this button to return to the previous screen.
Click this button to continue.
107. This screen
P-2612HNU-Fx User's Guide