ZyXEL Communications P-2612HNU-Fx User Manual page 111

The following table describes the labels in this screen.
Table 17 Network > WAN > Internet Connection: IPoA (DSL WAN Interface)
LABEL
WAN IP Address
WAN Subnet
Mask
Enable NAT
Enable IGMP
Multicast Proxy
Back
Next
Bridging
This screen displays when you select Bridging in the previous section for an
Ethernet WAN interface. For the DSL WAN interface, this shows if you set the DSL
Link Type field in the Network > WAN > Layer 2 Interface screen to EoA and
select Bridging in the previous section.
Figure 25 Network > WAN > Internet Connection: Bridging
The following table describes the labels in this screen.
Table 18 Network > WAN > Internet Connection: Bridging
LABEL
Connection Type
Service Name
IP Address
NAT
IGMP Multicast
Back
Save
P-2612HNU-Fx User's Guide
DESCRIPTION
Enter the static IP address provided by your ISP.
Enter the subnet mask provided by your ISP.
Select this option to enable NAT on the ZyXEL Device.
Select this check box to have the ZyXEL Device act as an IGMP proxy
on this connection. This allows the ZyXEL Device to get subscribing
information and maintain a joined member list for each multicast
group. It can reduce multicast traffic significantly.
Click this button to return to the previous screen.
Click this button to continue.
DESCRIPTION
This is the encapsulation method used by this connection.
This is the name of the service.
This shows whether the WAN IP address is assigned by the ISP,
manually configured or not configurable.
This shows whether NAT is active or not for this connection.
This shows whether IGMP multicasting is active or not for this
connection.
Click this button to return to the previous screen.
Click this button to save your changes.
Chapter 5 WAN Setup
111