ZyXEL Communications P-2612HNU-Fx User Manual page 230

Chapter 17 Quality of Service (QoS)
The following table describes the labels in this screen.
Table 65 Advanced > QoS > Class Setup: Add/Edit
LABEL
Class Configuration
Active
Class Name
Classification
Order
Forward to
Interface
DSCP Mark
802.1p Mark
VLAN ID
To Queue
Criteria Configuration
Use the following fields to configure the criteria for traffic classification.
Basic
From Interface
230
DESCRIPTION
Select to enable or disable this classifier.
Enter a descriptive name of up to 32 printable English keyboard
characters, including spaces.
Select an existing number for where you want to put this classifier to
move the classifier to the number you selected after clicking Apply.
Select Last to put this rule in the back of the classifier list.
Select a WAN interface through which traffic of this class will be
forwarded out. If you select Unchange, the ZyXEL Device forward
traffic of this class according to the default routing table.
This field is available only when you select the Ether Type check box.
If you select Mark, enter a DSCP value with which the ZyXEL Device
replaces the DSCP field in the packets.
If you select Auto Mapping and there is a VLAN tag carried in the
matched packets, the ZyXEL Device will replace the IP ToS field with
the 802.1p priority field.
If you select Unchange, the ZyXEL Device keep the DSCP field in the
packets.
Select a priority level with which the ZyXEL Device replaces the IEEE
802.1p priority field in the packets.
If you select Unchange, the ZyXEL Device keep the 802.1p priority
field in the packets.
If you select Remark, enter a VLAN ID number (between 1 and 4095)
with which the ZyXEL Device replaces the VLAN ID of the frames.
If you select Remove, the ZyXEL Device deletes the VLAN ID of the
frames before forwarding them out.
If you select Add, the ZyXEL Device treat all matched traffic untagged
and add a second VLAN ID.
If you select Unchange, the ZyXEL Device keep the VLAN ID in the
packets.
Select a queue that applies to this class.
You should have configured a queue in the Queue Setup screen
already.
Select whether the traffic class comes from the LAN or a wireless
interface.
P-2612HNU-Fx User's Guide