ZyXEL Communications P-2612HNU-Fx User Manual page 110

Chapter 5 WAN Setup
The following table describes the labels in this screen.
Table 16 Network > WAN > Internet Connection: IPoE (Ethernet WAN Interface)
LABEL
Obtain an IP
address
automatically
Enable DHCP
Option 60
Vendor Class
Identifier
Use the following
Static IP address
WAN IP
Address
WAN Subnet
Mask
WAN gateway
IP Address
Enable NAT
Enable IGMP
Multicast Proxy
Back
Next
IPoA
This shows if you set the DSL Link Type field in the Network > WAN > Layer 2
Interface screen to IPoA. This screen does not show for the Ethernet WAN
interface.
Figure 24 Network > WAN > Internet Connection: IPoA (DSL WAN Interface)
110
DESCRIPTION
A static IP address is a fixed IP that your ISP gives you. A dynamic IP
address is not fixed; the ISP assigns you a different one each time you
connect to the Internet. Select this if you do not have a static IP
address.
Select this to identify the vendor and functionality of the ZyXEL
Device in DHCP requests that the ZyXEL Device sends to a DHCP
server when getting a WAN IP address.
Enter the Vendor Class Identifier (Option 60), such as the type of the
hardware or firmware.
Select this if you have a static IP address.
Enter the static IP address provided by your ISP.
Enter the subnet mask provided by your ISP.
Enter the gateway IP address provided by your ISP.
Select this option to enable NAT on the ZyXEL Device.
Select this check box to have the ZyXEL Device act as an IGMP proxy
on this connection. This allows the ZyXEL Device to get subscribing
information and maintain a joined member list for each multicast
group. It can reduce multicast traffic significantly.
Click this button to return to the previous screen.
Click this button to continue.
P-2612HNU-Fx User's Guide