Layer 2 Interface Configuration - ZyXEL Communications P-2612HNU-Fx User Manual

Table 10 Network > WAN > Layer 2 Interface
LABEL
Add
Remove

5.2.1 Layer 2 Interface Configuration

Use this screen to create a new layer-2 interface. At the time of writing, you can
configure only one Ethernet layer-2 interface on the ZyXEL Device. However, you
can create multiple ATM layer-2 interfaces. The screen varies depending on the
interface type you selected in the previous section.
Click Add in the Network > WAN > Layer 2 Interface screen to open the
following.
Figure 16 Network > WAN > Layer 2 Interface: Ethernet WAN Interface
Configuration
Figure 17 Network > WAN > Layer 2 Interface: DSL ATM Interface Configuration
Note: VLAN MUX Mode is not supported by the ZyXEL Device as of writing.
P-2612HNU-Fx User's Guide
DESCRIPTION
Click this button to create a new
Check Remove and click this to delete this interface from the ZyXEL
Device. A window displays asking you to confirm that you want to
delete the interface.
Chapter 5 WAN Setup
interface.
layer-2
101