The Port Forwarding Edit Screen - ZyXEL Communications P-2612HNU-Fx User Manual

Table 34 Network > NAT > Port Forwarding
LABEL
Modify
Apply
Reset

8.2.2 The Port Forwarding Edit Screen

This screen lets you create or edit a port forwarding rule. Click the rule's Edit icon
in the Port Forwarding screen to open the following screen.
Figure 46 Port Forwarding Edit
The following table describes the labels in this screen.
Table 35 Port Forwarding Edit
LABEL
Active
Service Name
WAN Interface
Server IP
Address
External Start
Port
P-2612HNU-Fx User's Guide
DESCRIPTION
Click the edit icon to go to the screen where you can edit the port
forwarding rule.
Click the delete icon to delete an existing port forwarding rule. Note that
subsequent address mapping rules move up by one when you take this
action.
Click this to save your changes back to the ZyXEL Device.
Click this to return to the previous configuration.
DESCRIPTION
Clear the check box to disable the rule. Select the check box to enable it.
Enter a name to identify this rule using keyboard characters (A-Z, a-z,
1-2 and so on).
Select the WAN interface through which the service is forwarded.
You must have already configured a WAN connection with NAT enabled.
Enter the inside IP address of the virtual server here.
Enter the original destination port for the packets.
To forward only one port, enter the port number again in the External
End Port field.
To forward a series of ports, enter the start port number here and the
end port number in the External End Port field.
Chapter 8 Network Address Translation (NAT)
153