Configuring Static Route - ZyXEL Communications P-2612HNU-Fx User Manual

Chapter 16 Static Route

16.2 Configuring Static Route

Use this screen to view and configure IP static routes on the ZyXEL Device. Click
Advanced > Static Route to open the Static Route screen.
Figure 78 Advanced > Static Route
The following table describes the labels in this screen.
Table 59 Advanced > Static Route
LABEL
Add
#
Active
Status
Name
Destination
Subnet Mask
Gateway
Modify
220
DESCRIPTION
Click this to go to the screen where you can set up a static route on the
ZyXEL Device.
This is the number of an individual static route.
This indicates whether the rule is active or not.
You can change this in the Modify screen
This shows whether the rule is currently in use or not.
This is the name that describes or identifies this route.
This parameter specifies the IP network address of the final destination.
Routing is always based on network number.
This parameter specifies the IP network subnet mask of the final
destination.
This is the IP address of the gateway. The gateway is a router or switch
on the same network segment as the device's LAN or WAN port. The
gateway helps forward packets to their destinations.
Click the Edit icon to go to the screen where you can set up a static route
on the ZyXEL Device.
Click the Remove icon to remove a static route from the ZyXEL Device. A
window displays asking you to confirm that you want to delete the route.
(Section 16.2.1 on page
P-2612HNU-Fx User's Guide
221).