ZyXEL Communications P-2612HNU-Fx User Manual page 109

Table 15 Network > WAN > Internet Connection: PPPoE or PPPoA
LABEL
IP Address
PPPoE
Passthrough
Enable NAT
Enable IGMP
Multicast Proxy
Back
Next
IPoE
This screen displays when you select IP over Ethernet in the previous section for
an Ethernet WAN interface. This screen does not show for the DSL WAN interface.
Figure 23 Network > WAN > Internet Connection: IPoE (Ethernet WAN Interface)
P-2612HNU-Fx User's Guide
DESCRIPTION
Enter the static IP address provided by your ISP.
This field is available when you select PPPoE encapsulation.
In addition to the ZyXEL Device's built-in PPPoE client, you can enable
PPPoE pass through to allow up to ten hosts on the LAN to use PPPoE
client software on their computers to connect to the ISP via the ZyXEL
Device.
Each host can have a separate account and a public WAN IP address.
PPPoE pass through is an alternative to NAT for application where NAT
is not appropriate.
Disable PPPoE pass through if you do not need to allow hosts on the
LAN to use PPPoE client software on their computers to connect to the
ISP.
Select this option to enable NAT on the ZyXEL Device.
Select this check box to have the ZyXEL Device act as an IGMP proxy
on this connection. This allows the ZyXEL Device to get subscribing
information and maintain a joined member list for each multicast
group. It can reduce multicast traffic significantly.
Click this button to return to the previous screen.
Click this button to continue.
Chapter 5 WAN Setup
109